Bay Components

The Hybrid Bay Kit is a complete set of SMT Designs parts that can be assembled into fully functional electronics bay (customer supplies coupler tube, device, & battery).

The Modular Deployment/Tracker Nosecone Bay Kit is a complete set of SMT Designs parts that can be assembled into a fully functional module for the supported devices and batteries listed (customer supplies devices and batteries).

The Replacement Charge Canister is used to replace damaged or worn canisters in any of the 54, 65, or 75mm bay products from SMT Designs.

The replacement deployment hardware is used to rebuild hardware that has been damaged or corroded. It is used with any of the 54, 65, or 75mm bay products from SMT Designs.

The 38mm internal 1/4" motor retainer is used for both minimum diameter rockets as well as general motor retention for any rocket motor that has a Loki forward closure with a 1/4 threaded end.

The 38mm internal 5/16" motor retainer is used for both minimum diameter rockets as well as general motor retention for any rocket motor that has an Aerotech forward closure with a 5/16 threaded end.

The 38mm CT Bay Template is used to mark holes for drilling when constructing a coupler tube bay.

The BT60/38mm Fin Holder is designed to hold a single fin in place while the root tab is glued in place whether it is a through wall or air frame surface mount.

The 54mm End Cap Bay Stop is designed for both dual and redundant dual deploy bays and allows for the use of a motor retainer on both ends of a tubular bay.

The 54mm CT Bay Template is used to mark holes when constructing a coupler tube bay.

The 54mm BT Bay Template is used to mark hole locations in a body tube for the mounting of a coupler tube bay.

The 54mm Fin Holder is designed to hold a single fin in place while the root tab is glued in place whether it is a through wall or air frame surface mount.