98mm Components

The DD (Dual Deploy) End Cap is a 7.1mm (0.28") thick cap with a 2.38mm (3/32") shoulder. The end cap is used on the removable end of a bay and attaches to a mounting ring.

The RDD (Redundant Dual Deploy) End Cap is a 5.9mm (0.23") thick cap with a 2.38mm (3/32") shoulder. The end cap is used on the removable end of a bay and attaches to a mounting ring.

The 98mm Plug-In Bay is designed to install into a Wildman 98mm Nosecone coupler that has two 1/4-20 threaded rods running down from a pre-installed bulkhead at the top of the coupler. Once installed, a metal bottom stepped bulkhead is added and fastened down using 1/4-20 hardware.

The Hybrid Bay Kit is a complete set of SMT Designs parts that can be assembled into fully functional electronics bay (customer supplies coupler tube, device, & battery).

The Captured Modular Nosecone Bay Kit is a complete set of SMT Designs parts that can be assembled into a fully functional module for the supported devices and batteries listed (customer supplies device and battery).

The Standalone Modular Nosecone Bay Kit is a complete set of SMT Designs parts that can be assembled into a fully functional module for the supported devices and batteries listed (customer supplies device and battery).

The 8 Inch Fin Holder Kit is designed to hold a single fin (up to 3/8 thick) in place while the root tab is glued in place whether it is a through wall or air frame surface mount.

The 98mm Fin Holder is designed to hold a single fin in place while the root tab is glued in place whether it is a through wall or air frame surface mount.

The 98mm BT Bay Template is used to mark hole locations in a body tube for the mounting of a coupler tube bay.

The 98mm CT Bay Template is used to mark holes locations that need to be drilled when constructing a coupler tube bay.

The Replacement Charge Canister is used to replace damaged or worn canisters in any of the 98mm bay products from SMT Designs.